The action, although necessary, chemical treatment and filtration plant is not sufficient to guarantee the transparency of the water. Because this is always inviting you need to make constant maintenance, with the precious help of some effective and easy to use tools.
Maintaining a state of perfect health of the pool water is essentially linked to the filtration process. But they are not to overlook some mechanical operations, whose purpose is to remove the larger coarse inevitably sink to the bottom of the tank, because it should not be a burden on the filtration system. On that point fundamental action and vacuum cleaner, two instruments to combine a certain very practical affordability.
vacuuming The vacuum cleaner manual, operation hydraulic pump uses suction produced by the filtration system. It should be connected to the skimmer or sockets, to allow the filtration system to start its suction function.
The most common are:
- the broom with suction and rotating brushes with no elements: suitable for swimming coated liner that calls for a delicate
- the broom vacuum brush with rotating elements, more appropriate for hard coatings. The bristles, being rigid, allowing a more effective separation of impurities deposited on the bottom.
- the broom vacuum brushes with no rotating parts. Type most commonly used, as it requires no special precautions and is designated for each coating.
The broom vacuum is used:
- as soon as the pool was reopened. Its action allows you to send the accumulation of residues in water directly to the discharge, without compromising the filter. The action of this equipment requires a lot of water, affecting the need to make fresh water, which is essential in the process of restarting.
- during the period of inactivity. The water left in the tank during the winter has certainly deteriorated. Elements of different nature and chemical residues must be removed: minerals (calcium, chloride, manganese, iron) do not evaporate and alter the water balance.
- in the morning. When, after a day at the pool, pouring water into a product diluted flocculant, resulting in the precipitation of particles in suspension on the night bottom of the tank, the action of a manual vacuum exhaust will send such deposits so as not to overload the filter .
- following an intervention by flocculation, which is necessary especially during the summer months when the water becomes cloudy as a result greater attendance.
- when the winter approaches, the residues are removed from the exhaust using a manual vacuum and lower the water level to protect the suction outlets. The automatic vacuum
The category of automatic vacuum is diversified into three groups:
- those whose operation is done with a hydraulic system without the compressor;
- those that work with a hydraulic system but the compressor
-. Apparatus robot independent electrical.
The first variant consists of a broom and a hose ring. Uses the energy of the filter system and this is connected to the skimmer or to a specific socket. The choice should be made as needed and the pump capacity of the existing plant. A progressive loss of efficiency of which will come to stop then, indicates the filling of the filter and pump strainer. In order to prevent the strainer basket or skimmer pump will fill too quickly, it can be installed on the tube a device that literally traps the leaves and debris for less. The brush hood, always automatic, is generally regarded as an appendage of the filtration system, its action is rather slow, so that we avoid raising the minimum particles are instead to be pumped. In areas less visible to use the vacuum cleaner manual. As for vacuum cleaners that have the compressor, in this case the device in order to carry out its work, which requires a high pressure pump of the pool filtration system is unable to provide. That's why the fan has a compressor, fed by water from the filtering circuit, water is sent under pressure through the suction pipe of the tank. Friends
robot
They are the true stewards in the service of the pool. We refer to autonomous robots. It 'been shown by scientific studies that are deposited on the bottom of the pool most of the organic compounds rich in bacteria and that it is the aspiration of the latter to ensure the hygienic safety of water, of course next to the disinfection process. The market offers a wide choice of models with different design, functionality and power. These are electrical devices that operate at low voltage, batteries, and sometimes they have no link with the filtration system. Their filter traps impurities sucked and their rotating brushes can collect any kind of deposit on the bottom, on the walls, the entrances to the beach. Their characteristics make them suitable for any type of coating, without risk of abrasion, damage and scratches.
These devices are capable of: climb, climbing, turning, turn on themselves to change its path, trajectory established by those who make the program. This freedom of movement is permitted by the presence of an electronic component, and a microprocessor control unit programming.
The most basic models offer two wash cycles, one faster and one longer, while the more sophisticated have several programs that can be customized, as can make the choice and duration of the operation, offering the possibility of self programming, have the ability to handle the emerged part of the walls and then complete the task even under water. If there are obstacles in the tank they are even able to avoid them. Almost all models have a remote control.
Their enemies algae deposited on walls and bottom or inserted into the slots; fat deposits on the water line, insect or plant debris that could clog the filter basket. Autonomous and intelligent, these devices require, if you have a lot of pick-impurities, a method of cleaning, so that their suction power is not compromised.
0 comments:
Post a Comment